The FOB is a single part that replaces any type of three of four fletched arrows, either vanes or feathers that are normally applied to arrow shafts. FOB's are held in place with the nock that comes with your arrows. FOB's are designed to be used with fall away rests and carbon arrows only!
Standard FOBs are designed for all standard Internal Component System carbon shafts (ICS) using a standard 1/4′ nock (typical arrow internal diameter 0.243-0.248 +/-) as produced by Gold Tip, Easton, Beman, PSE, Redhead, Cabela's, Carbon Express etc.
The FOB's Ring Wing: 70% reduced cross wind drift with increased stability at any speed. The Positive Force Spinfins provide consistent spin every time allowing for easy tuning. Even with the biggest broadheads! The FOB's Super Tough HubPop Off design for quick pass throughs and increased penetration. The Air Foil leading edge is made to exacting specification for consistant repeatable shots.
Every Arrow flies the same
Like an airplane wing, the faster the FOB flies, the greater the force.
This force is equally applied at all points around the wing producing enormous stabilizing forces without increasing the drag.
Because the ring wing is only 1/2" long, it is virtually unaffected by crosswinds
Because the FOB does not deform in flight, chatter (which robs speed) and wobble is eliminated
All series/sizes with super nocks. Not for use uni-bushings, G-nocks or oversize shafts
All series/sizes with TCX nock or CX Meta Nock (bull dog nock collars removed)
All sizes-NOT for use with 3D LightSpeed
Easton X-7 Cobalt Aluminum 1914-2613
Not for use with Aluminum using uni-bushings
All sizes/series with standard GT nock - not for use with pin nock or oversize shafts